Ultra Start 450 SERIES Instruction Manual download pdf (Page 397)

100

101

Chapter 8 Diagnostics and Troubleshooting 377

Configuration Variables

The following table provides information about configuration variables that affect

the operation of OBDiag. Use the printenvs command to show current values and

the setenv command to set or change a value. Both commands are described in

“OBDiag Commands” on page 376.

test #,#, … Runs only the test(s) identified by menu entry number

(#) in the command line.

except #,#, … Run all test(s) except those identified by menu entry

number (#) in the command line.

what #,#, … Displays selected properties of the device(s) identified

by menu entry number (#) in the command line. The

exact information provided varies according to

device type.

Variable Setting Description Default

diag-level

off No tests are run at power up.

min Performs minimal testing of core

functionality.

min

med Performs functional tests for all

system functions.

max Runs exhaustive tests for all

functions except external loopbacks.

External loopback tests are run only

if diag-targets is set to

loopback, loopback2,or

loopbacks and diag-level is set

to max.

diag-continue? false Stops testing within a test routine

and prints a message as soon as an

error is detected. OBDiag then skips

to the next test routine in the

sequence.

false

true Causes OBDiag to run all subtests

within a test, even if an error is

detected.

diag-passes n Repeats each test the number of

times specified by n. Works with the

test, except, and test-all

commands.

Command Description

1 2 ... 392 393 394 395 396 397 398 399 400 401 402 ... 489 490

Comments to this Manuals

No comments

Ultra Start 450 SERIES Instruction Manual Page 397

Comments to this Manuals

Related products and manuals for Motor vehicle electronics Ultra Start 450 SERIES