Ultra-start 430 Series User Manual download pdf (Page 7)

Entering program mode is done by the following steps:

1) Make sure ignition is in the off position.

2) Turn the ignition key ON - OFF, leaving key in the OFF position.

3) Press and release the Valet button two times.

4) The siren will chirp one time to confirm entering program mode.

( If this does not happen, turn ignition off, wait five seconds and repeat steps 1-4).

To change settings:

1 - Enter Program Mode - (Ignition ON-OFF, followed by Valet 2 times)

2 - Press & release transmitter buttons in the following sequence

#1 - #2 then #3

3 - The siren will respond with the following:

1 Chirp Active Arming

2 Chirps Passive Arming

Repeat sequence to change selection

To change settings:

1 - Enter Program Mode - (Ignition ON-OFF, followed by Valet 2 times)

2 - Press & release transmitter buttons in the following sequence

#1 - #3 then #2.

3 - The siren will respond with the following:

1 Chirp Auto Lock Disabled

2 Chirps Auto Lock Enabled

Repeat sequence to change selection

To change settings:

1 - Enter Program Mode - (Ignition ON-OFF, followed by Valet 2 times)

2 - Press & release transmitter buttons in the following sequence

#3 - #3 then #2

3 - The siren will respond with the following:

1 Chirp Active Locks

2 Chirps Passive Locks

Repeat sequence to change selection

To change settings:

1 - Enter Program Mode - (Ignition ON-OFF, followed by Valet 2 times)

2 - Press & release transmitter buttons in the following sequence

#1 - #3 then #1

3 - The siren will respond with the following:

1 Chirp 3 Second Door Locks

2 Chirps 0.75sec Pulses

Repeat sequence to change selection

Passive / Active Arming

Enter Program Mode

Passive / Active Arming

Door Lock Timing

Ignition Auto Locks

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Ultra-start 430 Series User Manual Page 7

Comments to this Manuals

Related products and manuals for Car alarm Ultra-start 430 Series