Technical Support 866-698-5872 ext [email protected]/ID NoticeThis device complies with Part 15 of the FCC rules. Operation is subject to
1.Press and hold the UNLOCK button for three seconds.2.The doors will unlock, continue holding the unlock button three seconds. theTrunk release will
Starter DisableThe system has an optional starter disable output that can be connected by yourdealer. When the starter disable relay is installed and
87868587a3087868587a3087868587a3087868587a3087868587a30Negative Type Door LocksPositive Type Door Locks5 Wire / Reverse Polarity Type Door LocksNegati
Table Of Contents Page 2Wiring Diagram Page 3Installation Tips Page 4Pre-Installation SuggestionsInstallation SuggestionsMounting The ModuleInstalling
BlueConnect to hood and / or trunk pinHood InputGreenConnect to door pin. (-) when openedDoor InputPurpleConnect to door pin. (+) when openedDoor Inpu
Recommended Installation ProceduresWhite (+) Park lights Park light output.Orange (-) When Armed Negative output when system is armed.Grey (-) Trunk R
10 Pin Power ConnectorStep 2- Plug-In The ModuleStep 3- Test And Adjust The Shock SensorYour Basic Install Is Complete!Step 4- Test The SystemStep 1 -
Program mode allows you to adjust the settings and options of your system. Your systemhas been intelligently designed by installers with years of expe
Entering program mode is done by the following steps:1) Make sure ignition is in the off position.2) Turn the ignition key ON - OFF, leaving key in th
To change settings:1 - Enter Program Mode - (Ignition ON-OFF, followed by Valet 2 times)2 - Press & release transmitter buttons in the following s
- Press and release to arm the alarm and lock the doors. - Press and hold to activate Panic mode. - Press and release to deactivate triggered alarm.-
Comments to this Manuals